Thermostatic oil (water) bath pot notes - Huaqiang Electronic Network

Probe domestic switch needle KG-300K, needle head diameter is 3.0mm, normally open switch needle

MOS power IC full range available for various applications

KKST patch plug-in active and passive crystal oscillator, hot sale at 24.576000MHZ

First, the use of a constant temperature oil (or water) bath.

When using the device, it is essential to first fill the pot with water or oil before turning on the power. Once powered on, select the desired temperature. The green light indicates that the heating process has started, while the red light shows that the system is in standby mode. It's important not to overfill the container to prevent spills when the liquid reaches boiling point. Also, ensure that the electric heating element remains fully submerged in the liquid to avoid overheating and potential damage.

Second, the series of constant temperature oil (or water) baths.

The principle behind this device involves digital temperature display, touch control for setting, and a thermocouple sensor that measures the temperature. There is also an error correction knob that allows adjustments within ±1°C. The thermocouple (K-type sensor) sends the temperature signal to the control unit, which then generates both a measurement and a control signal. The measured temperature is shown on the digital display, while the control signal triggers the thyristor to regulate current flow. The green light indicates heating, and the red light signals that the heating has stopped. The system uses electronic proportional control, featuring automatic compensation and break protection. This ensures fast response and precise temperature regulation by interrupting the power supply ahead of time, allowing for near-instant switching.

Use: The operation method of the digital oil/water bath is similar to that of the digital water bath.

Third, things to be aware of when using a constant temperature oil (or water) bath.

1. For safety, always connect the grounding wire during use. 2. Never add water or oil to the pot when it is dry. 3. Due to the temperature difference between the surrounding environment and the bath, it is recommended to measure the temperature only after the system has reached a stable state. 4. There are sensors located between the heating elements. Avoid bumping or shaking the device to prevent damage.